Feb 28, 2019 · 0 PSI (barometric pressure, 1 Bar for the sensor): around 1.

572 volts @ 1 bar or 100 KPA Crome.

I can not get that to work. 00.

.

35 GM 3.

Pressure range: 2640 mbar (304 - 40 then x 10 to get mbar from kpa) Voltage range: 4. Jan 23, 2007 · Mopar 3 bar: MIN: 0. This way it won't run up off the MAP sensor, and then you scale the table sensor based on the vacuum the engine pulls.

GM 3 Bar MAP Sensor aka Manifold Absolute Pressure Sensor.

7 PSI (1 Bar of boost, or 2 Bar for the sensor): around 3. If you need assistance. Compare at $44.

. So, I adjusted the Map Sensor Linear/Offset from 312kpa/-11.

06 inHG.

GM 3 bar clone: MIN: 0.

. 12V, MAX 4.

3 bar map sensor Linear and offsets for HPtuners software MAP Sensor Linear: 333. .

80V, ZERO 2.
.
The only ref I can find is in a EVO forum thread and it says Scale.

.

Note that there are at least two different types of 'GM 3 bar sensors', so you may have to do some fine tuning.

The only ref I can find is in a EVO forum thread and it says Scale. . 80V, ZERO 2.

FITS GM 3 BAR MAP SENSOR KIT CUSTOM TURBO 3BAR 12223861 MANIFOLD PRESSURE AS210 44PSI. . Start with 41,800, 0 settings (scale, offset) Go to the "Map Watch" screen, and add "Advanced PIM". . 16V. Quantity.

4 kPa.

where x= sensor signal volts and y= kpa actual here (312. Note the PIM at atmospheric pressure (eg 9,950) = PIM0.

.

I can not get that to work.

08 max voltage 4.

Get it Dec 27 - Jan 5.

.